OK, I know I’ve been tardy about posting lately, but not very much has been going on. However, I’ve been re-invigorated by a trip up to the Autosport International show this week, along with Adrian. I didn’t actually buy anything but it was great looking at all the bits and we bumped into loads of fellow RGBers.
Archive for the ‘aerodynamics’ Category
And so, after a season of frenetic car building, engine swaps and sundry other excitements the RGB year ground to a halt at Cadwell at the weekend. It was, yet again, a wet weekend although a very enjoyable one. That the club managed to get 26 races on track over the 2 days, along with all the qualifying sessions, is a testament to how well organised it is. For something that only has two paid staff (and lots and lots of volunteers) this is pretty miraculous.
As discussed, I bit the bullet and remade some of the suspension components. First up is the rather short rear upper wishbone, as in the photo. It’s the iridescent white component. (I’ve got fed up using POR-15 which always goes a weird non-grey colour so I’ve decided to start spraying things like with rattle cans. As, oddly, Halfords don’t sell rattle cans for grey cars I settled on white as a decent light colour. Black would be nice but I’m paranoid about being able to see cracks appearing.
So, it was back to Snetterton for the final test. This was a Club MSV OPL trackday. So, no lap timing but I really just wanted to get comfier in the new car.
It’s getting closer and closer to the first race, although I’ve got one more test before then, but I’m thinking more and more about the race. (That is, I’m getting very nervous!)
So, I’ve just been doing a few bits and pieces really. First up was fixing a small problem. I found at the recent Snetterton test that when I climbed into the car I tended to whack my knee on the connector on the bottom of the Palm, breaking it! So, I’ve put a little extension on the bottom of the mounting plate to hopefully support it a bit better.
